|
Darksat
|
 |
« on: August 24, 2007, 03:56:09 pm » |
|
Well if you look at this image you can see that the top edge of the strip runs from corner to corner, so all you need to do is create a stripe, rotate it 45 degrees and paste it into a square image, move it untill it runs from corner to corner, then create a new layer, paste it in again and move so the edge of the strip touches the other corner on the empty side of the strip.
Then everything should fit together.
if you need more specific instructions let me know.
|
|
|
|
|
|
|
|
